Parts Diagram Components | Enviro C-10825, Evolution specs

Parts Diagram - Components

��

�

��

�

��

Evolution Domestic - Components

February 2005

��

�

��

��

33

Image 33

Enviro C-10825, Evolution owner manual Parts Diagram Components

Contents

Evolution Table of Contents Introduction I. Pellet StandardsStore pellets at least 36 1 m away from the pellet stove USE of Cordwood is Prohibited by LAW Keep ASH PAN Free of RAW Fuel Operating Instructions Reasons WHY the Unit Overheated Initial START-UP See above Thermostat / Switch Mode Tools Required to Clean Unit Routine Cleaning and MaintenanceBurner POT and Liner 2-3 days Heat Exchanger Tubes 2-3 days ASH PAN weekly Door Glass Cleaning 2-3 daysFresh AIR Intake biannually Exhaust Passages biannually Cleaning Plated Surfaces Post Season CLEAN-UPDoor Glass Replacement Brick Panel Screws to take out to remove stove from pallet Installation Dimensions of EF5 Maximum Alcove depth Inches Installing Hearth Pad Pedestal onto EF5 Crawlspace, narrow Walkway Closely Exhaust Fresh Air Intake Horizontal Exhaust Through Wall Installation Venting horizontally with rise Inside Vertical Installation Outside Vertical Installation Exterior Blower Kit Through vent hole Through Wall Installation with Exterior Blower Kit EF5 REQUIRED, please follow the instructions below If you wish to adjust the slider damper externally not Special Notes Slider Damper Located Behind Left Side panel. To open Stove will not operate when hot TroubleshootingDo not What to do if 200 F 93 C high limit temperature sensor has tripped Exhaust motor will not function normallyLight # 2 on Heat output bar flashing Convection blower will not function normally Control settings Heat Level has no effect on the fireIgnitor- the pellets will not light Stove keeps going out 5V DC Wiring Diagram Reference Number Description Part Number Parts List Parts List Parts Diagram Components SteelDiagramParts Warranty To the DealerTo the Distributor Name of Owner Address Installation Data Sheet