EPOS M Series manual Subwoofer Controls

You have the choice to use the plinth with, or without, the 6mm carpet spikes that are supplied together with it. The spikes can be adjusted to level the speaker and dig deep into carpet to provide mechanical de-coupling of the device into the floor. Metal discs are also supplied to prevent damage to wooden flooring, if required. To fix the plinth to the legs, use the four long bolts.

You may not wish to use the plinth, but mount the speakers flat to the floor, using only the four legs. This can be done by using the four shorter fixing bolts supplied to hold the legs to the bottom of the cabinet. If required, there are four self adhesive pads supplied which can glue onto the ends of the legs or the bottom corners of the plinth to prevent vibration or rattling, if the surface isn’t completely flat.

In the case of a multi-channel system (5.1), connect a shielded cable from the sub-sonic (LFE) output of your receiver to the RCA sockets on the back of the M subwoofer marked low level. You will note that there are two low level input sockets marked L & R, which allow for a stereo signal from your receiver or amplifier.

The specially designed summing circuitry in the M subwoofer combines the L&R low level input signals internally without forcing the source signal into mono.

Set all the controls to the middle position and switch on the M subwoofer using the switch marked POWER. A small LED indicator above the switch will light if everything is OK. Red indicates standby position and green is the indication for normal operation.

SUBWOOFER CONTROLS

You are now ready to set-up the system using the user guide or instructions from your receiver or DVD player. The sound balance can be adjusted with the controls on the rear panel of the M subwoofer.

HI-LEVEL OUTPUTHI-LEVEL INPUT

LOW LEVEL

R	L	R	L
			IN	OUT

++L

R

DO NOT

BLOCK

VENT

HOLES

			40Hz		80Hz
MIN	MAX	60Hz	20Hz	40Hz	120Hz	0	180
VOLUME		LOW FILTER		HI-FILTER			PHASE

RED = STANDBY

GREEN = ON

POWER

ON

OFF

POWER CONSUMPTION:

500 WATTS

AC~115V/60Hz

FUSE: T6 A 250V

AC~240V/50Hz

FUSE: T3.15A 250V

230V

AC VOLTAGE

SELECTOR

115V

N15057

RoHS compliant.

300 WATTS HIGH POWERED SUBWOOFER

SERIAL NUMBER

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

WARNING: SHOCK HAZARD - DO NOT OPEN

AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

AVERTISSEMENT: POUR PRÉVENIR LES RISQUES D’INCENDIE OU DE CHOC ÉLECTRIQUE, ÉVITER D’EXPOSER CET APPAREIL A LA PLUIE OU A L’HUMIDITÉ.

“WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH THE SAME TYPE OF FUSE”.

“AVERTISSEMENT: UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE”.

DESIGNED AND ENGINEERED IN ENGLAND.

www.epos-loudspeakers.com

IECEE CB No. CN 5679

Page 4