Epson 10050073 SAVE THESE INSTRUCTIONS

Urgent safety information;

THE UNIT MUST BE CONNECTED TO A POWER SUPPLYCIRCUIT THAT IS PROTECTED BY A GROUND FAULT

CIRCUIT INTERRUPTER (GFCI). A GFCI should be provided by the entrepreneur electrician and should be

routinely tested. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power

should be restored. If the GFCI fails to operate in this manner, there is a ground fault, indicating the possibility of

electrical shock. DO NOT USE THE UNIT. Disconnect the unit and have the problem corrected by a qualified electrician

before using.

Never operate electrically connected devices in or near the bath. Never drop or insert any object into any opening. Do not

use electrical appliances while in the tub.

To reduce the risk of injury, do not allow children to use this unit unless they are closely supervised at all times. Those

requiring supervision should never be allowed to use the units unattended.

Use the unit only for its intended use as described in this manual. Do not use attachments not recommended by the

manufacturer.

Never drop any objects into any openings.

Do not use the whirlpool if the protective cover is not installed on the suction intake. Keep foreign objects, including hair,

away from the suction intake as they could block the intake or get caught in it. For comfort and safety, persons with long

hair should tie their hair in a bun to keep it out of the water and away from the suction fitting. Keep your head above water

at all times.

Important safety information;

Persons under a doctor's care, pregnant women, persons with high or low blood pressure, heart disease, diabetes, or any

serious illness, should not use this unit without prior consultation with their physician. Never use this unit while under the

influence of any drug or alcohol.

The maximum temperature of the water should never exceed 104ºF (40ºC).

Information to prevent damage to equipment;

To reduce risk of injury, enter and exit the bath carefully.

Do not fill the tub beyond the air volume controls or the overflow.

Never operate the whirlpool system if there is less than 2" (5 cm) of water over the highest whirlpool jet (except for the

back jets) or if the bathtub is empty.

Do not bathe pets in your whirlpool. Their hair could clog the pump.

Make sure the water temperature does not exceed 104ºF (40ºC). Damage and discoloration of the acrylic surface may

occur.

The whirlpool should be drained after each use.

Oil-based additives can be used, but only if the frequency and cleaning instructions are followed.

Do not use harsh abrasives or solvents for cleaning your whirlpool.

• SAVE THESE INSTRUCTIONS •

WARNING