|
|
| EPSON Stylus 1500 |
| |
|
| 5. | Fan a stack of paper; then tap it on a flat surface to even the | ||
Loading Plain Paper in the Sheet Feeder | |||||
| edges. | ||||
|
|
| |||
You can load up to 100 sheets of plain paper. Always load | 6. | Load the stack of paper into the sheet feeder. Make sure the | |||
paper with the printable surface facing down. The printable |
| right edge of the stack is against the right edge guide. | |||
surface is marked with an arrow on most paper packaging. |
| Slide the left edge guide against the left edge of the paper. | |||
1.Make sure the
| TITLE | |
EPSON AMERICA, INC. |
| |
Documentation Department | DATE | 9/7/95 |
20770 Madrona Avenue, Torrance, CA 90503 |
| |
(310) | DRAWN BY B. Levert | |
|
|
|
2. Raise the output tray until it locks in the upright position.
3.Slide the right edge guide to the left as far as it will go. Slide the left edge guide to match your paper’s width.
4.Move the center support midway between the edge guides. Then gently extend the rear edge guide until it stops.
Note:
The sheet feeder can hold up to 100 sheets of
7.Adjust the rear edge guide to match the length of your paper.
When you load paper in the landscape direction (wider than it is tall), the rear edge guide may not match the length of your paper. In this case, remove the rear edge guide and
8.Lower the output tray to the printing position. Make sure that the rear edge guide of the paper tray is positioned under the output tray. The rear edge guide must be under the output tray to allow room for the paper loaded in the sheet feeder and to prevent a paper jam.
Testing the Printer
Before continuing, test the printer to ensure it is functioning properly. For the self test, use paper that is at least 8.25 inches (210 mm) wide. If you load narrower paper, the print head will spray ink directly onto the platen, which could mar future printouts.
Ink Jet Printers | 1/96 | EPSON Stylus 1500 - 9 |