3.2.10.1 Removingthe PF Motor
1. Remove the rear/front edgeguide assembly, front cover, paper eject assembly, rear/fronttractor
unit,and printer cover (seeSection 3.2.1).
2. Remove the panel board(see Section 3.2.2) andupper housingassemblies (see Section 3.2.7).
3. Remove the printer mechanism(see Section 3.2.10).
4. Remove the CBS screw (3×6, F/Zn) and CBscrew (3 ×8,F/Zn) securing the PF motor.
5. Disconnect connector CN10 fromthe C166 MAINboard assembly.
6. Remove the PF motorfrom the rightsub frame.
Before attaching the PF motor to the proper position on the right sub frame, set the release lever
to the full release position.
The CB screw (3 ×8, FZ/n) is used to secure the upper part of the PF motor. The CBS screw
(3 ×6, FZ/n ) is used to secure the lower part of the PF motor.
The tightening torque for the CB and CBS screws (3 ×8, F/Zn) = 0.78 ~ 0.98 Nm (8 ~ 10 Kg - cm)
CBS Screws (3 x 6 F/Zn)
Figure 3-18 Removing the PF Motor
Disassembly andAssembly FX-2170 Service Manual
3-14 Rev.A