3.2.10.3 Removingthe Right Frame Assembly
1. Remove the rear/frontedge guide assembly,front cover, papereject assembly, rear/front tractor
unit, and printer cover (see Section 3.2.1).
2. Remove the panelboard (see Section 3.2.2)and upper housingassemblies (see Section 3.2.7).
3 Remove theprinter mechanism (see Section 3.2.10), CR motorassembly (see Section 3.2.9),PF
motor, (seeSection 3.2.10.1) and PG sensorassembly (see Section 3.2.10.2 ).
4. Remove the hexagonnut (standard, M4) securing the gapadjust lever. Then, removethe gap
adjust lever from the right frameassembly.
5. Remove 2 CBS screws (3×6, F/Zn) securing the platen cover.
6. Remove 3 CBS screws (3×6, F/Zn) securing the right frameassembly atthe positions illustrated.
7. Remove the right frame assembly.
Adjust the platen gap and bidirectional print alignment. Refer to Chapter 4.
3.2.10.4 Disassembling the Right Frame Assembly
1. Remove 1 CBS screw(3 ×6, F/Zn ) and 1CBS screw (3×8, F/Zn) securing the right sub frame.
(The boldline in the illustrationis the right sub frame.)
CBS Screw (3 x6) Securing the Right Frame Assembly
Figure 3-21 Removing the RightFrame Assembly
CBS Screw (3 X6 FZ/n )
Securing the Right Sub Fram CBS Screw (3 x 8 F/Zn)
Securing the Right Sub Frame
Right Sub Frame
Figure 3-22 Removing the RightSub Frame
Disassembly andAssembly FX-2170 Service Manual
3-16 Rev.A