ActionPrinter 3250

CAUTION; If you lower the paper-release lever while continuous paper is still loaded, the printer beeps and the READY light goes off. If this happens, raise the paper- release lever and press the FORM FEED and FONT buttons at the same time to revense the paper to the paper-park position. You can then lower the lever again

3.The printer is ready to print. When it receives data, it automatically loads a single sheet from the paper cassette and begins to print.

Switching to continuous paper

To switch from single sheets back to continuous paper, follow these steps:

1.If a single sheet is in the paper path, press the FORM FEED button to eject it.

2.Raise the paper-release lever to the push-tractor position.

3.The printer is ready. When the printer receives data, it loads continuous paper from the push tractor automatically and begins to print.

Printing on Special Paper

In addition to printing on single sheets and continuous paper, your printer can print on a wide variety of other paper types, such as envelopes, labels, and multi-part forms.

Adjusting the paper-thickness lever

Before you print on special paper, you may need to change the paper-thickness setting for the paper you are using.

1.Remove the printer cover and set the paper-thickness lever to match the thickness of your paper. Choose the setting from the table below.

Paper Type

Lever Position

l-1

Note: Setting the paper-thickness level to 1 reduces the printing speed.

2.Replace the cover.
Envelopes

You can use the manual insertion slot to print a individual envelopes.

Always load envelopes manuaIly through the rear slot.

Before loading an envelope, set the paper-thickness lever to position 1 and lower the flap on the printer’s rear.

Always feed envelopes by inserting the wide edge into the printer first, as shown.

Use envelopes under normal operating conditions only.

Printing on the edge of an envelope can damage the print head. Make sure your application program keeps the printing entirely within the printable area of the envelope.

Installation/Support Tips

AP-3250 Beep Codes

2 Long and 2 Short = Indicates that the printer has completed its power-on initialization process and is ready to print

1 Short =The escape code for “BEL” has been received

3 Short =

Paper out condition

5 Long =Illegal paper change condition* or a printer fatal error**

•= 1) The optional pull tractor’s paper release lever was set to the TRACTOR position without first ejecting the cut- sheet paper.

2) The optional pull tractor’s release lever was set to the FRICTION position without first ejecting the continuous paper.

**= 1) Power supply voltage error

2)Internal air temperature error

3)Print head temperature error

4)Line feed or carriage motor is overheated

Short beep = 100ms beep with 100ms pause between beeps Long beep = 500 ms beep with 500ms pause between beeps

AP-3250-8

3 / 1 7 / 9 2

24-Pin Printers