Light state | Cause and solution | |||
|
|
|
|
|
|
|
| warning light is | |
|
| |||
|
|
| ||
flashing orange | hot again, projection stops automatically. Make sure there | |||
|
|
|
| is plenty of space around and under the projector for |
|
|
|
| ventilation. Clean or replace the air filter if necessary (see |
|
|
|
| |
|
|
|
|
|
|
|
| warning light is red | The projector is too hot, which turns off the lamp |
|
|
| ||
|
|
| ||
|
|
|
| automatically. Let it cool for five minutes, then turn it back |
|
|
|
| on. Make sure there is plenty of space around and under |
|
|
|
| the projector for ventilation. Also, clean or replace the |
|
|
|
| filter if necessary (see page 48). |
|
|
|
| If you are using the projector at an altitude above 4900 |
|
|
|
| feet (1500 meters), turn on High Altitude Mode so the |
|
|
|
| fan can properly cool the projector at the high altitude air |
|
|
|
| pressure (see page 46). |
|
|
|
|
|
|
|
| warning light is | The lamp needs to be replaced (see page 50). Make sure |
|
|
| ||
|
|
| ||
flashing red at | you have a spare lamp handy. Check to make sure the | |||
lamp and lamp cover are securely installed. | ||||
|
|
|
|
|
|
|
| warning light is | There is an internal problem. Turn off the power switch on |
|
|
| ||
|
|
| ||
flashing red at | the back of the projector, and unplug it from the electrical | |||
outlet. Then contact Epson for assistance (see page 60). | ||||
|
|
|
|
|
Solving Picture Problems
You cannot turn on the projector.
■Make sure the power cord is connected and the power switch is turned on. Then wait a moment for the power light to turn orange before pressing the P Power button.
■If you’ve set the Operation Lock, the control panel buttons are disabled; you must use the remote control to turn on the projector (see page 31).
56 Problem Solving