Epson 7000 Series Control Panel, Control Panel Buttons and Functions, Control Panel Lights and Messages, Error conditions, Normal printer operation

EPSON Stylus Pro 7000 series

Control Panel

Control Panel Buttons and Functions

Button	Function
Power	Turns the printer on and off.
Cleaning	Runs print head cleaning when pressed for
	3 seconds.
Pause (Reset 3 Sec.)	Stops printing temporarily. Press a second time
	to resume printing.
	Clears print data in the printer memory if
	pressed and held for three seconds.
	Returns the printer to READY status, when
	pressed in SelecType mode.
SelecType	Causes the printer to enter SelecType mode
	when pressed in READY status.
	In SelecType mode, this button can be used to
	select a desired menu.
Paper Source (Item)	Selects the paper source: Roll Auto Cut, Roll
	Cutter Off, or Sheet. If you press this button
	during the ink drying process, you will need to
	press Enter to make your setting.
	In SelecType mode, this button can be used to
	select an item in a menu.
Paper Feed ▲ (+)	Feeds paper in reverse.
	In SelecType mode, a desired parameter can be
	selected for the item (forward order).
Paper Feed ▼ (–)	Feeds paper forward.
	In SelecType mode, a desired parameter can be
	selected for the item (reverse order).
Cut/Eject (Enter)	Ejects the cut sheet when the Sheet light is on.
	Feeds the roll paper before cutting it when the
	Roll Auto Cut light is on.
	Feeds the roll paper a small amount when the
	Roll Cutter Off light is on.
	Feeds the roll paper and then prints a page line
	below the document when the Roll Cutter Off
	light and Print Page Line option are on.
	In SelecType mode, sets the selected parameter
	for an item as the default value.

Control Panel Lights and Messages

Normal printer operation

Message/Light	Explanation
READY/ Operate light on	Printer is ready to print.
PRINTING/ Operate light	Printer is receiving data.
flashing
INK DRY <number> MIN/	Printer is paused to let ink dry. Wait for
Pause light flashing	the number of minutes shown.
INK CHARGING	Printer is charging the ink delivery
<number> %/Operate and	system. Do not interrupt this process.
Pause lights flashing
TRANSPORT PREP	Printer is draining the ink lines to prepare
<number> %/ Operate light	for transportation.
flashing
RESET/ all lights flash briefly	Printer is resetting.
PRESS PAUSE BUTTON/	Press the Pause button to continue.
Pause light on
WAIT/ Pause light on or	Printer is warming up, initializing, or
flashing	charging ink.
PAUSE/ Pause light on	Printer is paused. To resume printing,
	press the Pause button.

Error conditions

Message/Light	Explanation	Response
COVER OPEN/	Lower cover is open.	Close the lower cover.
Pause light on
INK LOW/ Ink Out	Ink cartridge(s) are	Replace ink cartridge(s)
light(s) flashing	nearly empty (printing	indicated by Ink Out
	continues).	light(s). See page 8.
INK OUT/ Ink Out	Ink cartridge(s) are	Replace ink cartridge(s)
light(s) on	empty (printing stops).	indicated by Ink Out
		light(s). See page 8.
LOAD PAPER/	Paper set lever is down	Pull the paper set lever up
Paper Out light on	while loading paper.	after you load the paper.
LOAD ROLL	Paper source setting in	Make sure the right
PAPER	print options is different	paper is loaded and the
LOAD SHEET	from control panel.	paper source setting is
PAPER/ Paper		the same on the control
Out light on		panel and print options.
MAINTENANCE	A printer part will need	Note the error number
REQ. <error	to be replaced soon.	and contact EPSON.
number>
MAINTENANCE	The waste ink system is	Contact EPSON to
REQ. 0100	almost full.	schedule service.
NO INK	Ink cartridge(s) not	Install ink cartridges as
CARTRIDGE/ Ink	installed.	indicated by the lights.
Out light(s) on		See page 8.
OPTION I/F	Wrong interface card	Turn off the printer and
ERROR	installed.	remove the card.
PAPER JAM/	Paper has jammed in the	Remove the jammed
Paper Out light	printer.	paper.
flashing
PAPER NOT CUT/	Roll paper was not cut	Cut the paper manually,
Paper Out light	completely.	then remove the cut
flashing		paper from the printer.
		Reload paper.
	Cut paper did not fall off.	Remove the cut paper
		from the printer. Reload
		paper.

6 - EPSON Stylus Pro 7000 series 8/00