EPSON Stylus Photo 700/EX Service Manual
Chapter 3 Disassembly and Assembly
3.1 OVERVIEW
Since the structure of printer mechanism and the connection between the mechanism and the electrical circuits are the same with EPSON Stylus Photo, disassembly and assembly of the unit can basically be made by referring to the procedures described in EPSON Stylus Photo Service manual.
The procedures described below are only applicable to EPSON Stylus Photo 700.
3.1.1 C233MAIN board removal for EPSON Stylus Photo 700
1.Housing removal. (refer to EPSON Stylus Photo Service manual / Chapter 3, Section 3.2.1)
2.“SHIELD PLATE, M/B” removal.
(refer to EPSON Stylus Photo Service manual / Chapter 3, Section 3.2.2)
3.After dismounting “SHIELD PLATE, M/B” from the printer, remove all cables from C233MAIN board.
4.Remove seven screws (4: fixing C233MAIN, 3: fixing C233MAIN from the outside of “SHIELD PLATE, M/B”) and remove C233MAIN board.
|
|
| Table |
|
|
|
|
|
|
| Connector |
| Connected to |
|
|
|
| ||
| CN3 |
| ÖControl panel (C209PNL) |
|
| CN4 |
| ÖPrinter mechanism (PE Sensor) |
|
| CN5 |
| ÖPrinter mechanism (HP Sensor) |
|
| CN6 |
| ÖPrinter mechanism (CR motor) |
|
| CN7 |
| ÖPrinter mechanism (PF motor) |
|
| CN8 |
| ÖPrinter mechanism (Printhead: VH, Nozzle select data) |
|
| CN9 |
| ÖPrinter mechanism (Printhead: Nozzle drive signals) |
|
| CN10 |
| ÖPower supply unit (C206PSB/PSE) |
|
| CN11 |
| ÖPrinter mechanism (ASF Sensor) |
|
S c r e w
S c r e w
Figure 3-1. C233MAIN Removal
Rev. A |