EPSON PhotoPC 700
❏Do not use near water or handle with wet hands. For indoor use only.
❏Do not use within reach of children.
❏Do not charge the batteries using an electrical outlet on an airplane.
Follow these steps to charge your batteries for the first time:
1.Lift up the cover of the charger and insert all four batteries, positioning the + and – ends as shown. Then close the cover firmly.
+
+
+
+
2.Turn the charger over and flip the two prongs out of their compartment.
3.Plug the charger into an electrical outlet. Both lights turn red, indicating that the charger is working. When the batteries are fully charged, after about two and a half hours, the lights go off.
NOTE
The charger lights flash to indicate changes in battery temperature and voltage. If the lights continue to flash for more than half an hour, the batteries may be damaged or worn out, and should be replaced. Unplug the charger if the batteries are not fully charged after four hours.
4.Now charge your batteries again by opening and then closing the charger. The second charge should take about two and a half hours.
5.Charge the batteries a third time by opening and closing the charger again. This charge should take about 20 minutes.
6.After you have charged the batteries three times and both lights are off, unplug the charger. To avoid overcharging, don’t leave the charger plugged in for long periods of time after the lights go off.
7.Wait one hour until the batteries cool before removing them from the charger.
8.Before storing the charger, press down on the prongs to lock the plug into place.
(For subsequent charges of your NiMH rechargeable batteries, follow steps 1 through 3, then unplug your charger and follow steps 7 and 8 above.)
Be sure to always charge the batteries completely to make them last as long as possible. They can be recharged hundreds of times, so do not dispose of them until they are worn out.
NOTE
Keep the charger terminals clean by wiping them with a dry cloth. Make sure you charge all four batteries before you use them. If you find that your batteries run out faster after you recharge them a few times, make sure you discharge them completely before recharging. If this doesn’t help, replace the batteries.
Installing Batteries
Before you install the batteries, make sure the camera is turned off (the lens cover is closed). Then follow these steps:
1.Turn the camera upside down with the LCD screen facing you.
2.Push the battery cover lock down. While holding the lock, slide the battery cover to the left to open it. Then raise the cover.
4 - EPSON PhotoPC 700 | 5/98 |