caution

When replacing batteries, take the following precautions:

■Don’t mix old and new batteries.

■Replace batteries as soon as they run out. If the batteries leak, wipe away battery fluid with a soft cloth. If fluid gets on your hands, wash them immediately.

■Do not expose batteries to heat or flame.

■Dispose of used batteries according to local regulations.

■Remove batteries if you won’t be using the projector for a long period of time.

Power

Freeze

A/V Mute

R/C ON

E-ZoomOFFon/off

3switch

2

4

1

5

 

Enter

light

Escbutton

Turning On and Using the Remote Control

Before using the remote control, you need to install its batteries and turn it on as described below.

Installing Batteries

Follow these steps to install or replace the batteries:

1.Press the tab to release the battery compartment cover.

tab

2. Remove the cover and insert the two AA batteries included with the projector as shown.

3. Replace the battery compartment cover.

Turning On the Remote Control

Make sure batteries are installed. Then push up the on/off switch on the side of the remote control to turn it on.

If you want to make sure the batteries are good, press the round light button. The other buttons on the remote should light up

temporarily. If they don’t, you need to change the batteries as described above.

Turn off the remote control before transporting it or storing it in a projector case. This prevents the batteries from discharging if something presses against one of the buttons.

28Using the Remote Control