Epson PowerLite 737c Projector
3.Click the Configure button. Then click the Advanced tab on the screen that appears. You see a screen like this:
4.Ad hoc mode: Highlight Network Type in the Property list and set the Value to 802.11 Ad Hoc.
Access point mode: Highlight Network Type and set the Value to Infrastructure.
5.Ad hoc mode: Highlight SSID and set the Value to match the name you gave the projector’s ESSID (for example,
CONF ROOM).
Access point mode: Highlight SSID and set the Value to match the name assigned to the access point.
Note:
The SSID is
6.Highlight Encryption and make sure it is disabled.
7.Click the General tab and make sure the network card or wireless network device is enabled.
8.Ad hoc mode: Click OK to close the network card’s properties dialog box. Then go to “Projecting Wirelessly” on page 15.
Access point mode: On the General tab, select Internet Protocol, then click the Properties button. You see this screen:
9.If your access point uses DHCP, select Obtain IP address automatically. Otherwise, select Use the following IP address and enter the required information.
❏IP address: Type in the IP address you want to assign to the computer. It must be formatted like other addresses on the network; usually the first three sections (XXX.XXX.XXX) match the access point’s IP address, and the last section is unique.
❏Subnet mask: For example, 255.255.255.000, but this too must match how your network is set up.
❏Default gateway: Enter the IP address that was assigned to the access point when it was set up.
10.When done, click OK.
11.Click the Wireless Networks tab. You see this screen:
Note:
If you don’t see this tab, you may need to enable your wireless card or network device by clicking Configure to access the device settings; then follow any instructions on the screen to enable the device.
2/05 | Epson PowerLite 737c Projector - 13 |