EPSON Stylus Photo 750
Replacing an Ink Cartridge
You can replace a cartridge when the B black or A color ink out light is either flashing or on. (If you perform these steps when both ink out lights are off, the printer cleans the print heads, as described in “Cleaning the Print Head” on page 9.)
Use these EPSON ink cartridges within six months of installing them and before the expiration date on the package:
Black ink cartridge S020187
Color ink cartridge S020193
To ensure good results, use genuine EPSON cartridges and do not refill them. Other products may cause damage to your printer not covered by EPSON’s warranty.
Follow these steps to replace ink cartridges:
6.Remove only the yellow part of the tape seal on top as shown below. Don’t pull off the blue portion or try to remove the clear seal underneath the cartridge.
Remove the yellow tape
black cartridge color cartridge
You must remove the yellow tape from the top of the cartridge or you will permanently damage it. Do not remove the clear seal from the bottom of the cartridge; ink will leak out
1.Make sure the printer is turned on and not printing, then open the printer cover.
2.Press the R cleaning button and hold it for about three seconds until the print head moves left and the Ppower light begins flashing.
To avoid damaging the printer, never move the print head by hand.
3.Pull up the ink cartridge clamp. The cartridge rises up from its holder.
7.Lower the new ink cartridge into its holder with the label facing up and toward the back of the printer. Then press down the ink cartridge clamp until it locks in place.
4.Lift the cartridge out of the printer and dispose of it carefully.
If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water.
5. Remove the new ink cartridge from its packaging.
8 - EPSON Stylus Photo 750
Don’t open the clamp or remove a cartridge except to replace it with a new one. Once you remove a cartridge, you can’t reuse it, even if it contains ink.
8.If you need to replace the other ink cartridge, repeat steps 3 through 7 before going on to step 9.
9.Press the R cleaning button and close the printer cover. The printer moves the print head and begins charging the ink delivery system. The Ppower light flashes, and the printer makes various sounds.
Charging takes about one minute. When it’s finished, the
Ppower light stops flashing and stays on.
Never turn off the printer while the Ppower light is flashing, unless the printer hasn’t moved or made any noise for more than 5 minutes.
2/99