EPSON Stylus Photo 750
5.Remove the ink cartridges from their packages. Then remove only the yellow part of the tape seal on top. Don’t pull off the blue portion or remove the clear seal on the bottom of the cartridge.
Remove the yellow tape
black cartridge color cartridge
You must remove the yellow tape seal from the cartridge top or you will permanently damage it.
6.Load the ink cartridges as shown with the labels facing up and toward the back of the printer. Then press down the clamps until they lock into place.
Loading Paper
1.Open the output tray extensions. Slide the left edge guide right until it is a little wider than your paper.
Left edge guide 
2.Load a stack of plain paper and slide it against the right edge guide. Then slide the left edge guide against the paper’s left edge. Don’t load paper higher than the arrow on the guide.
Load paper only | Slide paper |
up to this arrow | against the right |
If ink gets on your hands, wash them thoroughly with soap and water. If ink gets in your eyes, flush them immediately with water.
7.Press the R cleaning button to begin charging the ink delivery system, then close the printer cover.
Charging takes about a minute. The Ppower light flashes and the printer makes noise until it’s finished.
Don’t turn off the printer or interrupt the charging process or it will start over, using more ink than necessary. Charging is finished when the Ppower light stops flashing and stays on.
Never turn off the printer while the P power light is flashing, unless the printer hasn’t moved or made any noise for more than 5 minutes.
Testing the Printer
You can run a printer operation check to determine whether the problem comes from the printer itself or some other source. If the check page prints, the problem lies in your software or application settings, the interface cable, or your computer. If the check page does not print correctly, you may have a problem with your printer.
1.Make sure both the printer and computer are turned off.
2.Disconnect the interface cable from the printer.
3.Make sure paper is loaded in the printer.
4.Hold down the E load/eject button, then press and release the Ppower button. Continue holding down the
E load/eject button until the Ppower light starts to flash, then release it. The printer prints its ROM version number, an ink counter code, and a nozzle check pattern (as shown on page 10).
5.After the test page prints, turn off the printer. Reconnect the interface cable and turn on your printer and computer.
6 - EPSON Stylus Photo 750 | 2/99 |