Sanyo VA-SW8000 Network Extension Mode, 7NETWORK INTERFACE CARD NIC, 8USE MORE THAN 1001 DVRS

Initial Set Menu

(Required user access level: ID4)

●Network Extension Mode

By default, the DVR Utility Software supports up to 1,000 DVRs connected to the network. If you want to connect more DVRs to the network, you can activate the network extension mode, in which you can connect up to 4,000 DVRs. To do so, follow these steps:

7NETWORK INTERFACE CARD (NIC)

This drop-down list contains network interface cards installed in your system. Choose one network interface card from the list.

8USE MORE THAN 1001 DVRS

To switch to the extension mode, select the “USE” radio button.

•USE:

Sets the number of DVRs to 1,001 or more (extension mode)

•NO USE (default):

Sets the number of DVRs to within 1,000

9MAX NUMBER OF UNITS

Once you have activated the extension mode (by selecting USE), you can specify the maximum number of DVRs. When you open the drop-down list, it displays several choices for the number of DVRs that can be connected based on the value of the network interface card’s subnet mask. Choose the most suitable choice.

Subnet mask value	Number of
	DVRs connected
255.255.252.0	Up to 1,000
255.255.248.0	1,001 - 2,000
255.255.240.0	2,001 - 4,000

For the system to correctly operate, one of the above three subnet mask values must be chosen.

FControl buttons

•:

Before you click [OK], you can cancel your changes by clicking this button.

•:

Applies and saves your changes.

When you are done, click [OK] to save your changes.

Some settings do not take effect until you quit the DVR Utility Software and reboot the computer.

☞Settings that take effect immediately when you click [OK]:

•DOWNLOAD AUTHORITY

•AUTO CLOCK ADJUST TIME

•SEQUENCE

☞Settings take effect after the computer is rebooted:

•LANGUAGE

•TV SYSTEM

•PC TYPE/MASTER CONTROL PC

•NETWORK INTERFACE CARD

•Network extension mode

75English