Epson PowerLite Pro Cinema 800
Cleaning and Replacing the Air Filter
Clean the air filter on the bottom of the projector once every three months, or more often in dusty environments. If it’s not cleaned periodically, it can become clogged, preventing proper ventilation. This can cause overheating and damage the projector.
1.Press the P Power button and wait for the P power light to stop flashing.
2.Turn off the projector using the power switch on the back.
3.Unplug the power cord and disconnect any cables.
4.Turn the projector over.
5.Then use a small vacuum cleaner designed for computers and other office equipment to clean the filter. If you don’t have one, gently clean the filter using a very soft brush, such as an artist’s paintbrush.
If the dirt is difficult to remove or the filter is broken, replace it. Purchase part number V13H134A09 from an authorized Epson reseller.
6.If you need to replace the filter, release the tab and lift up the cover.
7. Remove the old filter and replace it with a new one.
8.To replace the cover, insert the tabs and press down until the cover clicks into place.
Replacing the Lamp
The projection lamp lasts from 1700 to 3000 hours, depending on usage. You can use the Info menu to check how long it’s been in use. It’s time to replace the lamp when:
❏The projected image gets darker or starts to deteriorate.
❏The projector’s warning light flashes red at
❏The message Replace the lamp appears on the screen when you start projecting.
Note: Lamp life results will vary depending on the selected mode, environmental conditions, and usage.
Purchase lamp part number V13H010L35 from an authorized Epson reseller.
Warning: Let the lamp cool fully (about an hour) before replacing it. In the unlikely event that the lamp has broken, small glass fragments may be present and should be removed carefully to avoid injury.
Caution: Never touch the lamp with your bare hands; the invisible residue left by the oil on your hands may shorten the lamp life. Use a cloth or glove to handle the new lamp.
Follow these steps to replace the lamp:
1.Press the P Power button and wait for the light to stop flashing.
2.Turn off the power switch on the back of the projector and unplug the power cord and any cables.
3.If the projector has been on, let it cool for about an hour.
4.Press in the latches securing the lamp cover and lift off the cover.
11/05 | Epson PowerLite Pro Cinema 800 - 9 |