Epson PowerLite 821p Projector
4. If you need to replace the filter, slide it off as shown.
5.Align the new filter carefully as you slide it in until it clicks into place.
Follow these steps to replace the lamp:
1.Press the P Power button twice to turn off the projector. When you hear the projector beep twice, unplug the power cord.
2.If the projector has been on, allow it to cool down for at least half an hour (or until the lamp is cool).
Warning:
Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to avoid injury.
3.Use the screwdriver included with the replacement lamp to loosen the screw holding the lamp cover (located on top of the projector).
4.Slide the cover out, then lift it off.
5.Use the screwdriver to loosen the two screws holding the lamp in place. (You can’t remove the screws.)
Replacing the Lamp
The projection lamp typically lasts for about 2000 hours of use (in high brightness mode) or 3000 hours (in low brightness mode). It is time to replace the lamp when:
❏The projected image gets darker or starts to deteriorate.
❏The 
warning light is flashing orange.
❏The message Replace the Lamp appears on the screen when the lamp comes on. To maintain brightness and image quality, replace the lamp as soon as possible.
Note:
You can check how many hours the lamp has been used in the Info menu.
Turn the projector off when not in use. Continuous use may reduce the overall life of the product.
Contact your dealer or call Epson at (800)
Loosen these screws
6. Hold the lamp as shown and pull it straight out.
12 - Epson PowerLite 821p Projector | 9/04 |