Epson PowerLite 821p Projector
Warning:
This product includes a lamp component that contains mercury (Hg). Please consult your state and local regulations regarding disposal or recycling. Do not put it in the trash.
7.Gently insert the new lamp. If it doesn’t fit easily, make sure it’s facing the correct way.
Caution:
Do not touch the glass portion of the lamp assembly. Touching the glass could result in premature lamp failure.
8.Once the lamp is fully inserted, tighten its screws.
9.Lower the lamp cover into place. (The opening should be almost covered, and the top of the lamp cover should be flush with the surface of the projector.) Then slide the cover closed and tighten the screw.
10.Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
You must reset the lamp timer after replacing the lamp to clear the Replace the Lamp message.
Note:
Do not reset the lamp timer if you have not replaced the lamp. If you do, the Lamp Hours will not accurately reflect the number of hours that the lamp has been used.
1.Connect the power cable and turn on the projector.
2.Press the Menu button on the remote control and select the Reset menu. Then press Enter. You see the following:
3.Select
4.Select Yes and press Enter.
5.Press Esc to return to the Reset menu or the Menu button to exit the menu system.
9/04 | Epson PowerLite 821p Projector - 13 |