EPSON Stylus COLOR 900
6.Place the black ink cartridge in its holder with the label facing up and toward the back of the printer. Then press down the clamp until it locks into place.
7.Press the R cleaning button to move the color ink cartridge holder into the installation position.
If the print head doesn’t move to the color ink cartridge installation position, hold down the cleaning button for three seconds until the print head moves to the color ink cartridge installation position.
8.Repeat steps 5 and 6 to install the color ink cartridge.
9.Press the R cleaning button to begin charging the ink delivery system and then close the printer cover.
Charging takes about two minutes. The P power light flashes, and the printer makes various sounds until it is finished. Don’t turn off the printer or interrupt the charging process or it will start over and you’ll use more ink than necessary. Charging is complete when the P power light stops flashing and is stays on.
Never turn off the printer when the P power light is flashing, unless the printer hasn’t moved or made any noise for more than five minutes.
Testing the Printer
You can run a printer check to determine whether the problem comes from the printer itself or some other source. Follow these steps to run the printer check:
1.Make sure both the printer and computer are turned off.
2.Disconnect the interface cable from the printer.
3.Make sure paper is loaded in the printer.
Load paper that’s at least 8.27 inches (210 mm) wide. This prevents ink from spraying inside the printer and smudging your printouts.
4.Hold down the E load/eject button, then press and release the Ppower button. Continue holding down the E load/ eject button until the Ppower light starts to flash, then release it.
The printer prints one page showing its ROM version number, ink counter, and a nozzle check pattern in black, magenta, cyan, and yellow. Only the nozzle check pattern is shown below.
5.To end the check, turn off the printer after it prints the check page. Then reconnect the interface cable and turn on your printer and computer.
❏If the results are satisfactory, the problem lies in your software settings, the interface cable, or your computer.
❏ If the check page does not print correctly, you may have a problem with your printer. First try cleaning the print head (see page 10). Then try the suggestions in “Problems and Solutions” in the Printer Basics book or “Troubleshooting” in the EPSON Stylus COLOR 900 Manual.
6 - EPSON Stylus COLOR 900 | 1/99 |