DIP switch and jumper settings

Before you install the C82307* /C82308* interface, you may need to adjust the DIP-switch 2, DIP-switch 3, and jumper settings. You can change the DIP-switch 1 settings after you install the interface. When making DIP-switch setting changes, it is best to use a pointed device, such as a ball-point pen or small screwdriver.

Caution

All changes of DIP-switch and jumper settings should be made with the printer power turned off. New settings become valid only when the printer is turned on.

DIP switches

The settings on DIP switches allow you to change interface functions. The three sets of DIP switches on the C82307* /C82308* are labelled SWl, SW2, and SW3. Each set contains a number of individual toggle- type switches that can be set either on or off. The individual switches are referred to by set (SW1, SW2, or SW3) and number. Therefore, the switch in set SW1 marked by the small number 3 is called DIP switchl-3.

5