6 Press the ink button and close the printer cover.
The green power light flashes as your printer charges ink for several seconds.
CAUTION: Don’t turn off the printer while the green power light is flashing, unless the printer hasn’t moved or made any noise for more than 5 minutes.
4Load Paper
1 Fan a few sheets of paper and place them against the right edge guide. Make sure the paper is under the tabs on the edge guides.
Don’t push the paper in.
Don’t load paper above this arrow
2 Press in the side of the left edge guide and slide it against the paper, but not too tightly.
5 Connect the
Print Server
1
2 Plug the print server into the printer’s parallel port. Secure it with the wire clips.
3 Connect a network cable to the 10/100 connector on the print server. Then connect the other end of the cable to a hub or switch.
NOTE: The print server will automatically use DHCP to obtain an IP address. If it cannot get an IP address this way, it will use the private IP address of 192.168.192.168.
If you’re not using DHCP, see the online Administrator’s Manual for instructions on assigning an IP address to the printer.
Print server |
|
DCIN connector | V5 NIC |
| D |
| S ATA UT D A |
| ST |
10/100 connector | 0 |
| 0/101 |
4
5
6
Turn on the printer.
Plug the AC adapter’s power cord into a grounded electrical outlet. Then connect it to the AC adapter.
Press and hold down the status sheet button on the print server as you plug the AC adapter into the DCIN connector on the print server. Continue to hold down the status sheet button for about 10 seconds.
5VDCIN
USAAT
ATD
TS
0/11 00
DATA light 
STATUS light
Status sheet button
The STATUS light turns red as the print server initializes, while the DATA light above it stays green. Continue to hold down the status sheet button until the STATUS light turns orange or green.
NOTE: It can take up to one minute to initialize the print server.
7 When the print server is done initializing, press the status sheet button again for about two seconds to print a status report. If the report prints, the print server is installed correctly.
CAUTION: Before disconnecting the print server from the printer, always turn off the printer and unplug the AC adapter.