Epson CX11N, CX11NF Replacing the Photoconductor, Removing and Replacing the, Photoconductor, Handling Precautions

Epson AcuLaser CX11N/CX11NF

Replacing the Photoconductor

Handling Precautions

Always follow these precautions when replacing the photoconductor:

❏The photoconductor weighs 6.16 lb (2.8 kg). Be sure to hold it firmly by the handle when carrying it.

❏Avoid exposing the photoconductor to light any longer than necessary.

❏Be careful not to scratch the surface of the drum and belt. Also, avoid touching the drum; oil from your skin may permanently damage its surface and affect print quality.

❏Do not store the photoconductor in an area subject to direct sunlight, dust, salty air, or corrosive gases (such as ammonia). Avoid locations subject to extreme or rapid changes in temperature or humidity.

❏Do not tilt the photoconductor.

Warning:

Keep the photoconductor out of the reach of children.

Do not dispose of a used photoconductor in fire, as it may explode and cause injury. Dispose of it according to local regulations.

Removing and Replacing the

Photoconductor

1.Make sure the CX11N is turned on.

2.Remove any paper loaded in the ADF (CX11NF only).

3.Slowly flip back the scanner until it stops.

4. Close the output tray extension.

5. Lift up cover B.

6. Pull up the orange lever inside cover B.

7. Lift out the photoconductor using its handle.

8.Remove the new photoconductor from its package and pull off the protective sheet.

8/05 Epson AcuLaser CX11N/CX11NF - 13