Epson user manual Jumper, Transfer Speed Switching, DM-D110/D210 User’s Manual

Transfer Speed Switching

SW1-5	SW1-6	SW1-7	Transfer Speed
			(bps)
ON	ON	ON	2400
OFF	ON	ON	4800
ON	OFF	ON	9600*1
OFF	OFF	ON	19200*2
ON	ON	OFF	38400
OFF	ON	OFF	57600
ON	OFF	OFF	115200
OFF	OFF	OFF	(Reserved)

*1 Default Setting

*2 Setting that is used when connecting to the USB model of the EPSON TM printer.

Jumper

There are jumpers in the stand (DP-110/210) that configure whether a TM printer is connected to the DM-D110/210.

CAUTION:

Turn the power off before changing the jumper settings. Changing the jumper settings while the power is turned on may damage the device.

Use the following procedure to change the jumper settings.

1.Turn off the power switch; then remove the power cable from the stand.

2.Remove the plate from the base of the stand. For the DM-D110, press the two clips while lifting out the plate to remove the plate (see Illustration M). For the DM-D210, remove the two screws to remove the plate.

3.Change the jumper settings.

4.Attach the plate. For the DM-D110, press down on the plate until it latches into the clips on the stand (see Illustration N).

DM-D110

See Illustration C for the location of the jumpers.

JP1	JP2	Details
1-2	1-2	Use this setting if you are connecting and using both the TM printer and
		this device.
		(Default Setting)
2-3	2-3	Use this setting if you are using the DM-D stand in a stand-alone
		configuration without connecting a TM printer.

DM-D110/D210 User’s Manual 7