Quick Start Reference Sheet
Epson
Revision D
NOTE: This document is intended only as a quick reference for installation – please read the SP Controls Application Note for a complete description of this projector driver prior to installation.
I. Driver Features
1.Input Selection Mapping
Selection 1: VIDEO (RCA)
Selection 2:
Selection 3: YPbPr (BNC)
Selection 4: COMPUTER (VGA)
2.Hidden Function Mapping (Default Configuration)
Using the ON button as a shift key, press the following buttons to access the specified projector features.
Selection 1: ESC
Selection 2: ENTER
Selection 3: ADJUST LEFT
Selection 4: ADJUST RIGHT
Off: MENU
Volume Up: ADJUST UP
Volume Down: ADJUST DOWN
3. Other Driver Features
Power Status Feedback Method | Power Polling | |
Control Wiring: | Only |
II. Wiring Specifications
Although this driver does not use IR, SP Controls strongly recommends wiring for
NOTE: For a wiring diagram, please see the SP Controls Application Note.
Wire the Panel
TX to 2
RX to 3
GND to 5
Connect this female DB9 to the projector port labeled CONTROL
Wire the Panel IR/Serial port to a female 1/8" Mini as follows:
IR/SER to tip
GND to ring
Connect to the included IR Emitter and attach the emitter bud to the rear projector IR window. Note that
the projector does not consistently respond when the IR emitter is attached to the front IR window.
