List of Functions 58
fOthers menu
Sub Menu Function
SNMP trap IP
addressg 1/ SNMP
trap IP address 2
You can register up to two for the SNMPg trap notification destination.
You can input a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a
network administrator.
AMX Device
Discoveryg
When the projector is connected to a network, set this to "On" to allow the projector to be detected by AMX Device Discovery. Set this to "Off" if
you are not connected to an environment controlled with a controller from AMX or AMX Device Discovery.