You can monitor and control the projector from a computer, via USB.
This is done by connecting the projector and the computer with a USB
cable, and entering communication commands (ESC/VP21 commands).
Before You Begin
To monitor and control the projector with ESC/VP21 commands, the
following preparations must be carried out.
Procedure
A
Install the USB communication driver (EPSON USB-COM
Driver) to your computer. For information about the EPSON
USB-COM Driver, contact your local dealer or the nearest
address provided in the Support and Service Guide.s Epson
Projector Contact List
B
From the projector's Configuration menu, set Extended -
USB Type B to Wireless Mouse or Page Up/Down.
C
Similarly, set Link 21L to On from Extended menu.
D
Connect the computer's USB port to the projector's
USB(TypeB) port with a USB cable.
From second time on, start from step two.
Command List
When the power ON command is transmitted to the projector, the
power turns on and it enters warm-up mode. When the projec tor's
power has turned on, a colon ‘:’ (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ‘:’, and then accepts the next command.
If the command being processed terminates abnormally, an error
message is output and a ‘:’ is returned.
Item Command
Power ON/OFF On PWR ON
Off PWR OFF
Signal selection Computer Auto SOURCE 1F
RGB SOURCE 11
HDMI (EB-W8/X8 only) SOURCE 30
Video SOURCE 41
S-Video SOURCE 42
USB Display SOURCE 51
USB (EB-X8/S8 only) SOURCE 52
A/V Mute On/Off On MUTE ON
Off MUTE OFF
A/V Mute selection Black MSEL 00
Blue MSEL 01
Logo MSEL 02
Add a Carriage Return (CR) code (0Dh) to the end of each command and
transmit.
Communications protocol
•Default baud rate setting: 9600bps (the speed during communication
complies with the USB 1.1 standard.)
•Data length: 8 bit
•Parity: None
•Stop-bit: 1 bit
•Flow control: None
Monitoring and Controlling the Projector Using a Computer (ESC/VP21 Commands)87