65
Settings and
Adjustments
3Set the password.
(1) Select "Password", and then press the button.
(2) When the message "Change the password?" is displayed, select "Yes"
and then press the . The default setting for the password is
"0000". Change this to your own desired password. If you select
"No", the Password Protect setting menu shown in step 1 is displayed
again.
(3) Enter a four digit number using the numeric buttons. The number
entered is displayed as "* * * *". When you enter the fourth digit, the
confirmation screen is displayed.
(4) Re-enter the password. The message "Password accepted." is
displayed. If you enter the password incorrectly, a message is
displayed prompting you to re-enter the password.
Entering the Password
When the password entry screen is displayed, enter the password using the
numeric buttons on the remote control.
Enter the password by using the numeric buttons.
When you enter the correct password, projection begins.
•If an incorrect password is entered three times in succession, the message "The
projector's operation will be locked." is displayed for about five minutes, and then the
projector switches to standby mode. If this happens, disconnect the power plug from
the electrical outlet and then reinsert it and turn the projector's power back on. The
projector displays the password entry screen again so that you can enter the correct
password.
•If you have forgotten the password, make a note of the "Request Code: xxxxx"
number that appears on the screen and contact the nearest address provided in the
Inquiries.sp. 86
•If you continue to repeat the above operation and input the wrong password thirty
times in succession, the following message is displayed and the projector does not
accept any more password entries. "The projector's operation will be locked. Contact
Epson as described in your documentation."sp. 86