33
Configuration Menu Functions
Configuration Menu

"Settings" menu

(Setting is possible only when signals are being input from the [HDMI1]/[HDMI2]/[Component] input
port.)
This changes the display area (the part of projected images).
• Off, 2%, 4%, 6%, 8%: If set to "Off", the top and the bottom of the image are sometimes affected by
electrical interference depending on the image signal. In such cases, try to
adjust the display position ("Position"). p.32
• Auto:
Displayed when the signals from [HDMI1] / [HDMI2] input port are being input. This is
automatically set to Off or 8%, depending on the input signal. (Not displayed when the
equipment's DVI port is connected to the projector's [HDMI1] / [HDMI2] input port.)
(Setting is possible only when "EPSON Super White" is "Off". Setting is not possible, however, when
"Color Mode" is set to "x.v. Color.")
When the [HDMI1] / [HDMI2] input port of the projector is connected to a DVD player, for example,
setting this to Auto allows the projector to automatically determine and set the video range of the input
signal.
If this is set to Auto and a blackout/whiteout condition occurs, set the video range of the projector to
match that of the DVD player. The setting on the DVD player can be either Normal or Expand.
Note that if the equipment's DVI port is connected to the projector's [HDMI1] / [HDMI2] input port,
Auto is not displayed.
All the adjustment values on the "Signal" menu, except "Aspect ", are returned to their default values.
When the main power switch is turned on, you can set for projection to start (On) / not start (Off) without
pressing or .
When set to "On" with the main power switch left on, be aware that sudden surges of electricity that may
occur when the power comes back on after a power outage may cause the projector to turn on.
The projector is equipped with a power-saving function that causes the power to turn off automatically
and the projector to switch to standby if no signal is input to the projector for a continuous length of time.
The length of time before the power-saving function operates can be selected from four available settings.
If "Off" is selected, the power-saving function will not operate.
If you press while the projector is in standby mode, projection will start again.
This locks the power on function of the button on the projector's control panel, so that a child
cannot accidentally turn the projector's power on and look into the projector's lens. When the lock is
applied, the power will only turn on if is pressed down for about 3 seconds. can be used to
turn off the power, and the remote control will continue to operate as normal.
If you change the setting, the new setting will take effect after the power has been turned off and the cool-
down period is complete.
Even if "Child Lock" is set to "On", be aware that projection starts merely by turning the main power
switch on when "Direct Power On" is set to "On".
Not displayed when image signals are being input from a computer.
Overscan*
HDMI Video Range *

Reset

Direct Power On

Sleep Mode

Child Lock

* The setting values are stored separately for each image source and signal type.