48
Maintenance
Replacing consumables
Replacing the air filter
Replacing the lamp
Resetting the lamp operating time
Press the knobs to release the catches,
and then pull the cover upward.
Press or
to turn
off the power,
and then turn
the main
power switch
OFF.
Remove the air filter
cover.
Dispose of used air filters properly
in accordance with your local
regulations.
Frame material: PP
Filter materials: PP, PET
Do not touch the lamp cover soon after
power-off or you may get burned because
it is very hot.
TIP
* Wait until the lamp
cools down (takes
approximately 1 hour).
Insert the supplied screwdriver
of the replacement lamp into
the lamp cover opening switch,
then remove the lamp cover.
Securely tighten the
lamp fixing screws. Install the lamp cover.
Press or to
turn off the power, and
then turn the main power
switch OFF.
Wait until the lamp has cooled
down sufficiently before
removing the lamp cover. If
the lamp is very hot, you may
get burned.
If the lamp stops working
and needs to be replaced,
there is the danger that the
lamp may already be broken.
If replacing the lamp of a
projector which has been
installed to the ceiling, you
should always assume that
the lamp is broken and
handle it with extreme care
during removal. Furthermore,
you should stand to the side
of the projector, not
underneath it.
Press to turn on
the power.
Press to display
the configuration menu.
The lamp operating time
must always be reset after
the lamp has been replaced
with a new one.
The projector has a built-in
counter which keeps track
of the lamp operating time.
When the cumulative
operating time reaches a
certain point, it causes the
replacement warning
message to be displayed.