Adjustment of Extension Column
WARNING
•Extension column (A) must be fully threaded (six or seven full turns) onto threaded fitting in ceiling plate and then locked with M5 x 10 mm screw.
| Skip to step 3 if adjustment is not required. |
2 | Remove M8 x 10 mm phillips screw from set hole in extension column (A) as shown in fig. 2.1. Slightly loosen |
M8 x 10 mm phillips screw in hook slot until inner column is loose. Rotate inner column left and slide down in to |
desired hook slot as shown in fig. 2.2 and 2.3. Securely tighten M8 x 10 mm phillips screw in hook slot. Fasten M8 x 10 mm phillips screw into set hole and inner column and retighten M8 x 10 mm phillips screw in hook slot as shown in fig. 2.1.
A
fig. 2.1
M8 x 10 MM
PHILLIPS SCREW
SET HOLE
INNERCOLUMN
M8 x 10 MM
PHILLIPS SCREW
HOOK SLOT
WARNING
•Do not loosen M8 x 10 mm screw to point of disengagement. Hold inner column securely while adjusting M8 x 10 mm screw. Tighten fasteners securely.
M8 x 10 MM
PHILLIPS SCREW
INNERCOLUMN
fig. 2.2 |
| fig. 2.3 |
| ||
| ||
| ||
| ||
| ||
| ||
| ||
|
5 of 6 | ISSUED: |
Visit the Peerless Web Site at www.peerlessmounts.com | For Technical Support Contact Peerless Mounts at |