81
Lamp operating
error
This can happen when the power cord was
disconnected from the electrical outlet before
the cool-down period had finished the last
time the projector was turned off.
When turning off the projector, wait 2
minutes. After about 2 minutes, the cooling
fan will stop. When the cooling fan stops,
disconnect the power plug and then re-insert
it. When the power cord is plugged back in,
the projector will return to its previous state,
so press the [Power] button on either the
remote control or the projector's control panel
to turn it back on. If the lamp operating error
happens again when the power is turned back
on, remove the lamp and check if the lamp is
broken. If it is not broken, reinstall it. If it is
broken, replace it. Then press the [Power]
button on either the remote control or the
projector's control panel.If the indicators still
show a problem, stop using the projector,
disconnect the power cord from the electrical
outlet, and contact your dealer or the nearest
address provided at “International Warranty
Conditions” in
Safety Instructions/World-
Wide Warranty Terms
included in the package.
High
temperature
inside projector
(overheating)
The lamp will turn off automatically and
projection will stop. Wait for about 5 minutes
without operating the projector. After 5
minutes have elapsed, the projector’s cooling
fan will stop. Once the cooling fan has
stopped, unplug the power cord and then plug
it back in again.
If the projector overheats, check the following
two points.
•I s the setting-up location well ventilated?
Check that the air inlet and air outlet are
clear, and that the projector is not
positioned against a wall.
•I s th e air filter blocked with dust?
If the air filter is dirty, it should be cleaned.
When the power cord is plugged back in, the
projector will return to its previous state, so
press the [Power] button on either the remote
control or the projector's control panel to turn
it back on. If the projector continues to
overheat even after the above points have
been checked, or if the indicators show a
problem when the power is turned back on,
stop using the projector, disconnect the power
cord from the electrical outlet, and contact
your dealer or the nearest address provided at
“International Warranty Conditions” in Safety
Instructions/World-Wide Warranty Terms
included in the package.
P.18
P.92
Indicator status Projector
status Problem and remedy Reference
page
red red
red red