PSB No: P-0082

Page: 8 of 14

C f V m1 m2 n1 a is the command for changing the print position vertically (with respect to the Top of Form position) in units where ml, m2, nl and n2 are variables. TheZlnit”isuswllyl/~afaninchunlessdefinedatherwisebythe”ESC(U command. Currently, the values for ml and m2 MUST be ml =2 ‘and m2=0.

To determine the values for nl and n2 perform the following steps.

1.Determine the desired vertical dice from the Top of Form in inches.

2 Muttiplythe d i c e by380.

~

3.Divide the resutt by 258 using long division.

4.The remainder in the quotient from step 3 is the value for nl.

5.The whole number in the quotient from step 3 is the value for n2

EXAMPLE

1.The desired dice from the Top of Form is 1 inch.

21x380=380

3.36Odiidedby258== 1 witharemainderof104.

4.nl=lO4

5.n2=1

In the Basic programming language, the command would look like this.

Thiscommand,as~~~brthelineabwg.willpositionthepaperl inchfromthe current Top of Form setting. For example, if the Top of Form setting is the top edge of the paper, the paper will be positioned so that the printer is ready to print 1 inch down from the top edge of the paper.