Epson
Installing/Replacing the Battery
Follow these steps to install or replace the Lithium ion battery:
1.Turn the
2.If you need to remove the battery, follow the instructions below, then return here to step 3.
3.Insert the battery into the compartment as shown. Make sure the gold contacts on the battery go in first.
4.Close the battery cover and slide it to the right until it clicks.
BATT.
Removing the Battery
If you need to replace the battery or plan to store the
1.Make sure the
2.Remove the AC adapter if it is connected to the
Caution:
Never remove the battery while the
3. Open the battery cover.
4. Push the catch down. The battery pops out.
Catch
5. Pull out the battery. Then close the battery cover.
Charging the Battery
After installing the battery, you need to charge it using the AC adapter. It takes about 3 hours to fully charge the battery when the
The Charge light is green while the battery is being charged. When the battery is fully charged, the light turns off.
To charge the battery, connect the AC adapter as shown below. Connect the other end to the power cord, and plug it into an electrical outlet.
Caution: Do not connect the AC adapter when the battery is not installed; this can damage the
The battery status is displayed in the top right corner of the LCD screen when the
: |
|
| Battery is fully charged. |
|
|
|
|
|
|
|
|
: |
|
| Battery power is about half full. |
|
|
|
|
|
|
|
|
: |
|
| Battery power is low. |
|
|
|
|
|
|
|
|
: |
|
| Battery power is running out. The |
|
|
| automatically. Charge the battery using the AC adapter. |
|
|
| |
|
|
|
|
: |
|
| Battery is charging. |
|
|
|
|
|
|
|
|
Note: The
11/04 | Epson |