5
Installing the 3-inch take-up reel core
Note:
If you want to install a 2-inch take-up reel core instead,
see the next section for instructions. Also you can re-
use the core from a used paper roll. See your Online
Guide.
1. Make sure that the lock lever is released
(turned to the left). Slide the movable unit to
the left end of the horizontal strut.
2. Slip one end of the take-up reel core over the
flanged knob on the drive unit.
3. Insert the flanged knob on the movable unit
into the other end of the take-up reel core.
4. Turn the lock lever to the front to lock the
movable unit.
The installation of the 3-inch auto take-up reel
unit is complete.
Installing a 2-inch take-up reel core
If you want to use the 2-inch take-up reel core, you
need to reverse the flanges on the drive unit and
movable unit first. Follow the steps below.
1. Make sure that your printer is turned off.
2. Remove the cap and fastener from the drive
unit.