3
Installing the drive unit
1. Attach the drive unit on the horizon tal strut as
shown below.
2. Tighten the two screws to attach the drive unit
to the printer securely.
3. Plug the cable connector into the connector on
top of the control box of the drive unit, then
tighten the screws on both sides of the connector.
4. Plug the other end of the cable connector into
the connector on the back of the printer as
shown below, then tighten the screws on both
sides of the connector.
Installing the movable unit
1. Turn the lock lever to the left to release it.
2. While holding the movable unit, attach th e
movable unit stopper on the bottom of the
movable unit. Snap the two protrusions of the
stopper into the movable unit, so the stop per
does not fall off.
3. Tighten the two screws to attach the movable
unit to the horizontal strut.