PictureMate Pal (PM 200)
Removing and Installing a Photo Cartridge
Make sure you have a new PictureMate 200 Series Print Pack before you remove the old photo cartridge. Once you remove the cartridge, you must install the new one right away.
1.Make sure PictureMate Pal is on but not printing.
2.Open the cartridge door on the back of PictureMate Pal.
3. Slide the cartridge lever left, to the Release position.
Caution: Do not try to pull out the cartridge without moving the lever.
4.Pull out the cartridge and dispose of it properly. (For appropriate disposal, check local resources for recycling guidelines.)
Warning: Keep photo cartridges out of the reach of children and do not drink the ink.
If ink gets on your hands, wash them thoroughly with soap and water. If ink gets in your eyes, flush them thoroughly with water. If discomfort or vision problems continue after flushing, see a doctor immediately.
5. Remove the new photo cartridge from its package.
Don’t touch the green chip
Caution: Don’t touch the small green circuit board. Install the photo cartridge immediately after you remove it from its package. If you leave a cartridge unpacked for a long time before using it, normal printing may not be possible.
6.Slide the cartridge straight into the slot, label side up, until it clicks in place.
Note: The cartridge won’t go in all the way. You need to use the cartridge lever to lock it in place.
7. Slide the lever all the way right, to the Lock position.
Caution: If the cartridge is not inserted correctly, PictureMate Pal will not be able to print.
8. Close the cartridge door all the way.
PictureMate Pal starts charging and displays a message.
9. When it’s finished charging, press OK.
8 - PictureMate Pal (PM 200) | 6/06 |