Epson powerlite 1815p Setting the Remote Control ID, Press the, While holding the, 36Presenting with the Remote Control, 4. When done, press Menu to exit the menu system

note

If you’re using a remote control ID other than the default ID of zero, you have to set the ID each time you turn on the projector.

4. When done, press Menu to exit the menu system.

Setting the Remote Control ID

The remote control’s default ID is zero. This lets you operate any projector. To set it to operate a specific projector, follow these steps:

1.Point the remote control at the projector you want to be able to operate.2.Press and hold the ID button on the remote control.

3.While holding the ID button, press a numbered button on the remote control (0 through 9) to select the desired ID. Select zero to control all projectors, or select a number to match the ID of the projector(s) you want to operate.

After setting the ID, you can check whether the remote control works with a specific projector:

1.Point the remote control at the projector you want to check.

2.Press the ID button on the remote control. You see a message on the screen like one of these:

If the message says the remote control is “On,” then you can use the remote control to operate that projector. If it says “Off,” then you have to change the ID of the remote control and/or projector before operation is possible.

36Presenting with the Remote Control