Epson Stylus Photo R2400
8.Insert the left roll paper holder (marked with an orange triangle) into the far left slot (also marked with an orange triangle). Then insert the other holder into the corresponding slot on the right.
9.Load the paper part of the way into the roll paper feeder (under the white rollers), then slide the right roll paper edge guide to fit lightly against the paper.
Caution: Don’t load roll paper into the sheet feeder or the slot behind the paper support; make sure it is below the white rollers.
10.Push the paper into the feeder until the paper meets resistance. Maintain pressure on the paper until the printer feeds the paper automatically.
11.Open the printer cover and look down into the printer to make sure the paper is straight.
If crooked, press the
z roll paper button for three seconds
If the paper is crooked, press the z roll paper button for three seconds to back the paper all the way out.
Then turn the roll paper holder knobs to roll up the paper. Press the ) paper button to clear the paper out error. Repeat steps 8 through 10 to reload the paper.
Follow the instructions in your User’s Guide to print on roll paper.
Loading Thick Media in the Front Path
You can load media 1.3 mm thick into the front path, in sizes from 8 × 10 inches to A3+.
Note: Since the media feeds through the printer from the front to the rear, make sure there is enough space behind the printer for the media to move completely through the printer.
1.Turn on the printer and remove any paper loaded in the sheet feeder at the top of the printer.
2.Close the paper support at the top of the printer.
3.If the output tray and extension are open, push them in, but leave the flap at the end of the tray down.
4.Open the printer cover. Then open the front path door completely by pressing the front path door release area.
5. Close the printer cover.
2/05 | Epson Stylus Photo R2400 - 11 |