
RTC - 4543 SA/SB
7. Description of Operation
| 1 | 2 | 52 | 53 | 54 | 54+n |
CLK |
|
|
|
|
|
|
CE |
|
|
|
|
|
|
WR |
|
|
|
|
|
|
DATA | s1 | s2 s4 s8 s10 s20 s40 FDT | y8 y10 y20 y40 y80 |
|
|
|
|
| Sec | Year |
|
|
|
Output data does not change
1)When the WR pin is low and the CE pin is high, the RTC enters data output mode.
2)At the first rising edge of the CLK signal, the clock and calendar data are loaded into the shift register and the LSB of the seconds digits is output from the DATA pin.
3)The remaining seconds, minutes, hour, day of the week, day, month, and year data is shifted out, in sequence and in synchronization with the rising edge of the CLK signal, so that the data is output from the DATA pin.
The output data is valid until the rising edge of the 52nd clock pulse; even if more than 52 clock pulses are input, the output data does not change.
4)If data is required in less than 52 clock pulses, that part of the data can be gotten by setting the CE pin low after the necessary number of clock pulses have been output.
Example: If only the data from “seconds” to “day of the week” is needed:
After 28 clock pulses, set the CE pin low in order to get the data from “seconds” to “day of the week.”
5)When performing successive data read operations, a wait (tRCV) is necessary after the CE pin is set low.
6)Note that if an update operation (a
the data that is read will have an error of
7)Complete data read operations within tCE (Max.) = 0.9 seconds, as described earlier.
1 | 2 | 52 | 53 | 54 | 54+n |
CLK
CE
WR
DATA | s1 s2 s4 s8 s10 s20 s40 | 0 | y8 y10 y20 y40 y80 |
( FDT ) |
Seconds
Year
1)When the WR pin is high and the CE pin is high, the RTC enters data input mode.
2)In this mode, data is input, in succession and in synchronization with the rising edge of the CLK signal, to the shift register from the DATA pin, starting from the LSB of the seconds digits.
3)The
4)After the last data is input to the shift register at the rising edge of the 52nd clock pulse, the contents of the shift register are transferred to the timer counter.
5)Note that during a data write operation, 52 bits of data must be input.
•Correct
•If more than 52 bits of data are input, the 53rd and subsequent bits are ignored.
(The first 52 bits of data are valid.)
6)Once the CE pin is set low, the prohibition on carries to the seconds counter is lifted. Complete data write operations within tCE (Max.) = 0.9 seconds, as described earlier.
7)If a data read operation is to be performed immediately after a data write operation, a wait (tRCV) is necessary after the CE pin is set low.
* Malfunction will result if illegal data is written. Therefore, be certain to write legal data.
Page - 7 | MQ - 252 - 03 |