3

4

Slide the edge guide against the left side of the paper.

Extend the output tray.

Note: See your Basics book for instructions on loading paper in the rear sheet feeder.

5Install Software and

Connect to Your Computer

The software works with Windows® 98SE, Me, 2000, and XP, and Macintosh® OS X 10.2.x to 10.3.x. Follow the steps below (for Windows), or the steps on the back of this sheet (for Macintosh).

Windows

1 Make sure the RX700 is not connected to your computer, then turn on your computer.

Note: If you see several New Hardware Wizard screens, click Cancel for each of these screens and disconnect your RX700. You can’t install your software that way.

2 Insert your RX700 software CD-ROM in your CD-ROM or DVD drive.

Note: If you’re using Windows XP and you see a message asking what to do with your CD, click Cancel.

Turn over