English

Installing Horizontally or Vertically

You can install the printer horizontally (with the paper exit on top) or vertically (with the paper exit at the front) either on a flat surface or by hanging it on a wall (using the optional hanging bracket set, WH-10). Both the horizontal and vertical positions are shown below.

When you install the printer horizontally, attach the control panel label and position the roll paper near end sensor as shown in the illustrations. To move the sensor, follow these steps.

1.Loosen the screw with a coin or similar tool and turn it at least 3 or 4 times.

2.Push the lever gently as far as it will go.

3.Turn the tab (in the direction of the arrow in the illustration) while pushing the lever until it clicks into place in hole A.

4.Secure the screw and make sure the lever moves smoothly.

Note:tab

To hang the printer on the wall, see

the Wall Hanging Bracket Set screw Installation Manual provided with the WH-10 for instructions.

A

TM-L90 User’s Manual 5

Page 7
Image 7
Epson TM-L90 user manual Installing Horizontally or Vertically