English

4.Again turn the ribbon cassette’s knob 2 or 3 times in the direction of the arrow and close the ribbon cassette cover.

CAUTION:

Be careful not to touch the print head with your fingers when turning the ribbon cassette knob because the print head is hot and you might be burned.

When you replace the ribbon casette, lift the left side of the ribbon cassette first; then lift the whole ribbon cassette.

Inserting Roll Paper

CAUTION:

Be sure to use roll paper that meets the specifications.

Be sure not to touch the manual cutter. Otherwise your fingers might be injured.

1.Using scissors, cut the leading edge of the roll paper, as shown in illustration G.

2.Turn on the printer and open the roll paper cover by using the tab, as shown in illustration H.

3.Type A only: Open the unit by using the unit open lever, as shown in illustration I.

4.Insert the roll paper, as shown in illustration J.

Note:

Note the direction the paper comes off the roll, as shown in the illustration G.

When using 2-ply roll paper, be sure that the top and bottom sheets are aligned at the paper exit. See illustration G-a.

5.If you are not using a take-up spool, pull out a small amount of roll paper and close the roll paper cover; then tear off the paper with the manual cutter. You can skip steps 6 through 11.

6.Type A only: When using 2-ply roll paper, pull out the roll paper to the bottom front of the printer as a guide, as shown in illustration K.

7.Close the unit, as shown in illustration L.

8.Insert the end of the bottom paper (journal paper) into the paper take-up spool, as shown in illustration M.

9.Insert the paper take-up spool in the printer. Be sure that the paper is aligned with the spool’s flange, as shown in illustration N.

10.Feed the paper with the FEED button so that the paper is taken up by the spool.

TM-U220 User’s Manual 7