Epson WF-3540 Running a Product Check

LCD screen message Condition/solution

No dial tone detected. Make sure the phone cable is connected correctly and the phone line works.

Try the Check Fax If you connected the product to a PBX (Private Branch Exchange) phone line

Connection. or Terminal Adapter, turn off the Dial Tone Detection setting.

Combination of IP There is a problem with the network connection to your product.

address and subnet

mask is invalid. See

your documentation.

Recovery mode An error has occurred during firmware updating. Connect your product using

a USB cable and try downloading the Firmware Update from Epson's support

website. If you still need help, contact Epson for support.

Note: The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.

During the life of your product it may reach a condition where either satisfactory print quality cannot be

maintained or the ink pads have reached the end of their usable life. The EPSON Status Monitor, your

LCD, or lights on the control panel will advise you when these parts need replacing. If this happens

during the standard warranty of the product, the exchange of the product or replacement of the pads is

covered under the standard warranty. If the product is out of warranty, the pads can be replaced by any

EPSON authorized service provider. The waste ink pads are not a user-serviceable part.

Parent topic: Solving Problems

Related references

Paper Jam Problems in the Paper Cassette

Paper Jam Problems in the Duplexer (Rear Cover)

Paper Jam Problems Inside the Product

Where to Get Help

Related tasks

Checking for Software Updates