Equator BCR 500 manual Installation Instructions, ØBefore Using Your Beer Cooler

INSTALLATION INSTRUCTIONS

ØBefore Using Your Beer Cooler

·Remove the exterior and interior packing.

·Check to be sure you have all of the following parts:

·Instruction manual

·1 Safety Guard Rail

·1 Drip Tray (2 Pieces)

·1 CO2 Cylinder Support

·1 CO2 Regulator (Box)

·1 CO2 Empty Cylinder(Box)

·1 CO2 Air Line Hose (Red)

·1 Beer Keg Coupler (Box)

·1 Beer Tower

·1 Pull Handle (Beer Tower Faucet)

·1 metal wrench

·4 Plugs: For Guard Rail Holes

·1 Metal Plate For Cabinet Bottom

·2 Steel wire shelves

·1 Steel Clamp for Red Hose

·4 Casters with lock

·Before connecting the Beer Cooler to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

·Clean the interior surface with lukewarm water using a soft cloth.

ØInstalling Your Beer Cooler

·This appliance is designed to be free standing only, and should not be recessed or built-in.

·Place your Beer Cooler on a floor that is strong enough to support the Beer Cooler when it is fully loaded.

·Allow 3 inches of space between the back and sides of the Beer Cooler, which allows the proper air circulation to cool the compressor.

·Locate the Beer Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the Beer Cooler not to perform properly. This unit is not designed for outside installation (ie garages, porches etc.)

·Avoid locating the Beer Cooler in moist areas.

·Plug the Beer Cooler into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and or grounding should be directed toward a certified electrician or an authorized service center.

·After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing any contents in the Beer Cooler compartment.

7