2. Installation and Details for Caution Use
* Unless you follow the cautions properly, there may be life damage or material damage.
Correct Installation Procedures
zThis instrument is intended for indoor use only.
zInstall in areas with no influence of heat, such as direct ray of light and heater.
zInstall away from areas with either strong magnetic force or electrical noise.
zInstall on a flat and
zInstall in areas with no dusts and moistures.
zInstall in areas with no wind currents and radical thermal alterations.
zThis instrument is not suitable for use at altitude above 2000m.
Details for Caution Use – Make sure to check the power source before use.
zUse a soft cloth with appliance of alcohol when polishing the scale.
zKeep out water or any
zCheck to see if the scale is placed horizontally before use. If the scale is not in a horizontal position, use the horizontal positioning screw in order to adjust its position. (Have the foam inside of the level gauge be in the center.)
zWhen the scale is turned on, the display will be set to initial scaling condition after indicating
In order to maintain its electrical safeties, warm up the machine for approximately 10 minutes before use.
zMake sure the weight display is set to " 0 g " before use. If the display is not set to " 0 g ", use after setting the display to " 0 g " by pushing the "Zero/Tare" key.
zUse only authorized adapter.
zUse same kinds of batteries when using batteries.
zRemove the battery from the scale if not using the scale for a long time. It may cause damage to the scale from the leak of
zWeighing by over maximum capacity may cause damage to the scale.
zThis scale needs periodical inspection every two years.
zNever reorganize, repair or disassemble this scale. Inquire of a manufacturer of a distributor about after service.
