In a straight-through cable, wires 1, 2, 3, and 6 at one end of the cable are also wires 1, 2, 3, and 6 at the other end. In a crossed cable, the order of the wires change from one end to the other: wire 1 becomes 3, and 2 becomes 6.
To figure out which wire is wire number 1, hold the cable so that the end of the plastic RJ-45 tip (the part that goes into a wall jack first) is facing away from you. Flip the clip so that the copper side faces up (the springy clip will now be parallel to the floor). When looking down on the coppers, wire 1 will be on the far left.
CAT5 cabling should not exceed 100 meters. The following drawing depicts the typical wiring scheme for CAT5.
For more information about wiring an Ethernet network, please refer to the Linksys web site (www.linksys.com).
FireBall™ SE-D1 User’s Manual
PAGE 25
