Messages on the Display
ES-LINK
appears when the
No Word!
There is no clock source.
UNKNOWN
The unit connected via the IEEE1394 cable is unknown.
WRD ERROR!
Invalid word sync signal is received.
WRD UNLCK!
Cannot lock the word sync signal.
LOOP ERR!
IEEE1394 connection is looped.
<Normally, “the sampling frequency of an incoming digital signal” when a CD is played back or “DSD” when an Super Audio CD is played back are shown on the left of the display. At the right shows the output level.
<No output level shows when VOLUME BYPASS is switched on.
<When detecting a device that is connected with IEEE 1394 cable, the display shows its model name (such as
Troubleshooting
If you experience any problems with this unit, please take the time to look through this chart. You may be able to solve the problem yourself before calling your dealer or technical support.
No power
eCheck the connection to the AC power source. Check and make sure the AC source is not a switched outlet and that, if it is, the switch is turned on. Make sure there is power to the AC outlet by plugging in another item such as a lamp or fan.
No sound from speakers.
eCheck the connection to the digital device, amplifier and speakers.
eIf the volume bypass is off, adjust the output level using the OUTPUT buttons.
The INPUT indicator blinks.
eTurn on the digital device connected to the input terminal. eCheck the connection to the digital device. Make sure the
source digital device and the input selection on the
The safety circuit of the power amplifier is activated.
eSet 80kLPF to ON.
Buzzing noise produced at regular intervals.
eThe connected unit may not be in word sync mode while the
Normally, if this problem occurs, the display reads “WRD ERROR”, but this message does not appear when deviation in sync is too small and out of the word error detection threshold of the
The WORD indicator blinks.
The display shows “No Word!”
eThe word sync mode is selected, but there is no clock source. Turn the word sync mode off (see page 9).
eInvalid word clock is being received. Check cables, connections, and settings of the clock generator.
The display shows “WRD ERROR!”
eInvalid word sync signal is received. Check the setting of the clock generator.
The display shows “WRD UNLCK!”
eCannot lock the word sync signal. If “Rb IN” is selected, select “IN” using the WORD button.
If normal operation cannot be recovered, unplug the power cord from the outlet and plug it in again. This resets the internal
14
