KWORD

Use this to turn on or off the word sync function.

When the word sync is on, the unit will synchronize with an external word sync source.

LOPEN/CLOSE

Use this button to open and close the disc tray.

MCLEAR

Use this button to clear entry errors, etc.

NDISPLAY

Use this button to change the display mode.

OFL DIMMER

Use this button to change the brightness of the front panel display.

PREPEAT

Use this button to set the repeat playback mode.

QGROUP

This button doesn’t work on the SA-10.

RSKIP (.//)

Use these for skip operations.

SPAUSE

Use this to pause playback.

TRETURN

Use this button to go up a level in the setup menu.

Note:

To simplify explanations, instructions in this manual refer to the names of the buttons and controls on the front panel only. Associated controls on the remote control will also operate similarly.

How to insert the batteries

Remove the cover of the remote control unit with a screwdriver. After checking the polarity (+/_) of two AA batteries, insert the batteries, replace the cover and replace the screws.

<Take care not to pinch cables with the battery case.

ENGLISH

Battery Replacement

If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. In this case replace the batteries with new ones.

Precautions concerning batteries

<Be sure to insert the batteries with correct positive “+” and negative “_” polarities.

<Use batteries of the same type. Never use different types of batteries together.

<Rechargeable or non-rechargeable batteries can be used but not mixed together. Refer to the precautions on their labels.

<When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. If they leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones.

<Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire.

Notes on use

<Point the remote control unit at the player’s remote sensor within seven meters (23 feet) of the player. There should not be any obstacles between the player and the remote control unit.

<Do not allow direct sun or other light to shine on the remote sensor part of the player. This may cause the remote control unit to work incorrectly.

<Note that other units with remote controls may operate incorrectly because of infrared light “overspill” when you operate this remote control unit.

11