MATRIX-600 Specifications
Mixer:
Sensitivity / Impedance (for 1Vrms on PREAMP outputs, channels’ VOLUME controls and MASTER VOLUME in FCW position)
Ch.
Ch. | 50 mV / 20 k Ohms |
Ch. 5: XLR MIC input (balanced): | 5 mV / 2 k OhmsΩ |
Ch. 5: 1/4” TRS INSTRUMENT input (mono, unbalanced): | 75 mV / 1 M OhmsΩ |
Ch. 5: 1/4” TRS STEREO LINE input (unbalanced): | 150 mV / 1 M OhmsΩ |
Ch. 6: Stereo RCA and 3.5mm mini jack MP3/CD input |
|
(unbalanced): | 50 mV / 10 k Ohms |
Ch. 7: Stereo RCA HOUSE input |
|
(bypasses MASTER VOLUME): | 500 mV / 10 k OhmsΩ |
Frequency Response (with filters and EQs disabled): | 20 Hz – 20 kHz, |
Total Harmonic Distortion (at | <0.05% |
Signal/Noise ratio |
|
better than 100dB |
Loudspeakers:
Enclosure: | |
Woofer: | 10” high excursion |
Mid range driver: | 6.5” transducer |
Compression driver: | 1” Phenolic on exponential horn |
Frequency response: | 50 Hz – 20 kHz |
500 Hz, 2.5 kHz |
Phantom power on Ch. | 48Vdc |
Channels’ |
|
Ch. | Bass: shelf 150 Hz; |
| Mid: 1 kHz; |
| High: shelf 8 kHz; |
Ch. | Bass: shelf 100 Hz; |
| Mid: 2 kHz; |
| High: shelf 15 kHz; |
MASTER | |
| 1 kHz, 2.5 kHz, 6.3 kHz, 16 kHz |
SUBWOOFER filter: | 100 Hz at |
SUBWOOFER output: | 2 Vrms |
MONITOR output: | 3 Vrms |
RECORD output: | 0.25 Vrms |
General system:
Weight: Amp/mixer
Weight: Loudspeaker (each)
Dimensions: Amp/mixer (W x H x D) Dimensions: Loudspeaker (W x H x D) (each)
29 lbs (13.1 kg) 45lbs (20.4 kg) 10” x 17” x 10.25”
(254mm x 432mm x 260mm) 13.25” x 24” x 12.25” (337mm x 610mm x 311mm)
Amplifier:
Output power: | 2x300Wrms into 4 Ohms |
SUGGESTED APPLICATIONS:
Mobile DJ * Karaoke * Nightclub, Restaurant, Bar Install * Corporate Audio / Video * Home Entertainment System * Live Sound System * Stage Monitoring System * Booth Monitoring System
B
PROF
|
|
| L |
|
| A | |
| N |
| |
O |
|
| |
ESSI |
|
|
|
3383 Gage Avenue, Huntington Park, CA, 90255
Phone:
National:
Internet:
Note: Specifications are subject to change without notice
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause undesired operation.
